ACDSee Pro 6 Betriebsanweisung PDF herunterladen (Seite 290)

Chapter 6: Edit Mode

Adjusting Levels Automatically

You can use the Auto Levels tool to automatically correct the exposure levels of your images. Auto Levels makes the darkest image

pixels darker, and the brightest pixels brighter.

You can save your settings as a preset for future use.

To automatically correct an image's levels:

1. In Edit mode, in the Exposure/Lighting group, click Auto Levels.

2. Select one of the following options:

Auto Contrast and Color: Adjusts color differences, brightness, and balances RGB channels.

Auto Contrast: Adjusts the color differences and brightness only.

Auto Color: Balances the RGB channels in the image, without changing the brightness or contrast.

3. Use the Strength slider to fine tune the amount of exposure you want to apply.

4. Click Exposure Warning to make overexposed and underexposed pixels visible. Overexposed pixels turn red,

underexposed pixels turn green.

5. Do one of the following:

Click Done to accept your changes and close the panel.

Click Cancel to discard your changes and close the panel.

Click Reset to clear your changes and reset to default settings. If you saved your changes, you cannot reset your settings.

If you want to discard only the Edit settings, select File | Restore to Developed.

You can right-click a slider to reset to the default value.

You can use the Edit Brush to paint this effect onto specific areas of your image.

Adjusting Tone Curves

In Edit, you can use the Curves tool to change the tonal range of an image. Select the RGB color channel to adjust the entire range of

the image, or select a specific color.

You can save your settings as a preset for future use.

Remember that any changes you make with this tool in Edit, are pixel-based edits, recommended for final touch-ups to

your image. For non-destructive changes, use the Tone Curves tool in Develop.

To adjust the brightness curves in an image:

1. In Edit mode, in the Exposure/Lighting group, click Tone Curves.

2. Set the options as described below.

272

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 402 403

Keine Kommentare

ACDSee Pro 6 Betriebsanweisung Seite 290